RAL9006 Powder Coating
INTRODUCTION FH-MP Series is metallic finish powder coatings
with highly decorative finishes available in any of chemistry types e.g. epoxy, polyester and epoxy-polyester. To preserve the decorative appearance of polyester-based metallic finishes for outdoor use, a clear topcoat is highly recommended. FEATURES Metallic / Pearl Powder Coating
is a range of metallic effect powder mixed with pearl pigments ,copper,gold or aluminum silver # pigments, offering various colorful metal shining effects. Offering considerably improved mechanical properties and chemical resistance. Available in a range of chemistry types and can be custom matched as per user’s requirements. Clear Topcoat is recommended to overcoat. Dry blending or bonding options Bonded (FH-MP-B) and dry blending (FH-MP-D) metallic powder have very different properties during application .Both of them are optional according to your requirement. Bonded Metallic Powder (FH-MP-B) Base powder and metallic pigments does not be divided Can use after reclaimed Reclaim to virgin powder ration be kept as low as possible High Metallic Effect A little bit expensive No defects on a coated film Rejection ration Below 5% Metallic Powder had been combined with base powder Dry Blending Metallic Powder (FH-MP-D) Base powder and metallic pigments can be divided Can not use after reclaimed Tends to separate from the power during application Low Metallic Effect Cheaper than Bonded Metallic Powder Defects (spit, lump etc.) on a coated film Rejection ration 30~40% Base powder and metallic powder have been detached GLOSS AND COLOR RANGE Gloss levels range from matt to high gloss depending on the chemistry system. Smooth, flat metallics or sparkling metallics are available. Colors is matched upon request , no full color range is available. APPLICATION SCHEDULE Applied by electrostatic spraying gun that can provide negative tension of 60-80 kV. Curing schedule : 180-200°C /10-15 minutes depending on the powder chemistry system. Optimal film thickness : 60 -90 um The metallic finish obtained depends on the coating thickness. Excessively thin or thick films will not give a satisfactory finish. SUBSTRATES AND PRE-TREATMENT Applied to the following substrates after the appropriate cleaning and conversion coating. Ferrous metals(cold rolled steel, cast iron etc.): Iron or zinc phosphatation Zinc surfaces(galvanized steel, zinc alloy) : Chromatation or zinc phosphatation Aluminum alloys : Chromatation STORAGE Should be stored under dry conditions with good ventilation at a temperature not exceeding 30 C. Storage period recommended should not exceed 6 months, in case exceeding 6 months without affecting their free flowing properties, the powder will still have optimal characteristics. Should be protected from excessive heat, humidity, water and contamination with foreign materials such as powder, dust, dirt, etc. Any leftover powder should be kept in an appropriate area that is cool and dry. Do not expose to the air too long as the powder properties may deteriorate with the moisture We offer powder coating capabilities that include a wide spectrum of colors, thickness, textures, softness, edge coverage, flexibilities, machinabilities, smoothness and temperature ranges. Free samples are available. If you want to know more on Luster silver Ral 9006 Metallic Powder Coating
, please feel easy to contact me at Mobile phone: 0086 13952057195 Company Information
Contact us if you need more details on Ral9006 Powder Coating. We are ready to answer your questions on packaging, logistics, certification or any other aspects about Ral9006 Powder、Ral 9006 Metallic Powder. If these products fail to match your need, please contact us and we would like to provide relevant information.
Product Categories : Metallic/Pearl Powder Coating